Strengthening a 3D Printed Part

 Filling the Second Design With Epoxy and Fiberglass

First I shredded some amount of fiberglass and stuffed them into both of the parts until they are more than half full. Then started pouring small drops onto them and applying a bit of pressure to soak them.

Continued this until all fabric inside is wet and then added more fabric and epoxy step by step making the inside of the part is full. Then Screwed the round part on top of it. I continued filling the part, rising the level of epoxy-fiber mixture to the edge.

I did the same to the smaller part.
Pages: 1 2 3 4 5 6 7 8 9 10 11 12

Comments are closed.

indian porn sexnxxx.cc xvideos Amateur Porn video porno amatoriali filmeporno.top lupoporno film porno gratuit porno mature xnxx film porno gratuit
bisexuel gay porno gay porno video porno देसी सेक्स एचडी पॉर्न ऊपर ऊपर से चुदाई Големи цици only fans free porn videos filme porno gratis